ENGINE 3-21
ENGINE COMPONENTS INSPECTION AND SERVICE
CYLINDER HEAD COVER
"
DISASSEMBLY
• Remove the inspection caps
1.
• Remove the rocker arm shaft bolts
2.
• Remove the rocker arm shafts
3.
• Remove the rocker arms
4 and wave washers
5.
CYLINDER HEAD COVER DISTORTION
After removing sealant from the fitting surface of the cylinder
head cover, place the cylinder head cover on a surface plate
and check for distortion with a thickness gauge. Check points
are shown in Fig.
$ Cylinder head cover distortion
Service Limit: 0.05 mm
% 09900-20803: Thickness gauge
If the distortion exceeds the limit, replace the cylinder head
cover.
ROCKER ARM SHAFT O.D.
Measure the diameter of the rocker arm shafts.
$ Rocker arm shaft O.D.
Standard (IN. & EX.): 11.977 – 11.995 mm
% 09900-20205: Micrometer
Identify the position of each removed part. Organize
the parts in their respective groups (i.e., intake or
exhaust) so that they can be installed in their original
locations.
To Next Page
Loading...
