Suzuki RV125 - Inspection and Disassembly

CHASSIS 5-35
• Raise the rear wheel off the ground with a jack or wooden
block.
• Loosen the drive chain adjusters
7, left and right.
• Remove the rear axle
8.
• Disengage the drive chain from the rear sprocket.
• Remove the rear wheel.
• Remove the rear brake panel
9.
• Remove the rear sprocket
0.
• Remove the bearings by using the special tool.
" 09921-20240: Bearing remover set, or
09941-50111: Wheel bearing remover
!
INSPECTION AND DISASSEMBLY
WHEEL BEARINGS.....................................................................
#5-6
REAR AXLE SHAFT ............................................................... #5-6
WHEEL ................................................................................... #2-18
SPOKE NIPPLES ........................................................................
#2-19
TIRE ........................................................................................ #2-18
The removed bearing should be replaced with a new
one.