CHASSIS 5-13
CALIPER INSPECTION
Inspect the caliper cylinder wall and piston surface for scratch,
corrosion or other damages.
If any abnormal condition is noted, replace the caliper assembly
with a new one.
CALIPER REASSEMBLY
Reassemble and remount the brake caliper in the reverse order
of removal and disassembly. Pay special attention to the follow-
ing points:
Wash the caliper bore and piston with the specified brake fluid.
Thoroughly wash the dust seal groove and piston seal groove.
!
) Specification and classification: DOT 4
PISTON SEALS
• Install the piston seal
1 and dust seal
2 as shown.
RUBBER PARTS
• Replace the removed rubber parts with new ones.
* Wash the brake caliper components with new brake
fluid before reassembly. Do not wipe the brake fluid
off after washing the components with rag.
* Replace the removed piston seals and dust seals
with new ones. Apply brake fluid to all of the seals,
brake caliper bores and pistons before reassembly.
To Next Page
Loading...
