3-8 ENGINE
ENGINE INSTALLATION
Reinstall the engine in the reverse order of engine removal.
• Install the engine mounting bolts and nuts as shown in the following illustration.
• Tighten the engine mounting nuts to the specified torque.
NOTE:
The engine mounting nuts are self-locking. Once the nuts have been removed, they are no longer of any
use.
"
• Tighten the engine sprocket nut
1 to the specified torque.
# Engine sprocket nut: 90 N·m (9.0 kgf-m)
Left
Right
40 N
.
m
(4.0 kgf-m)
65 N
.
m
(6.5 kgf-m)
40 N
.
m
(4.0 kgf-m)
41 N
.
m
(4.1 kgf-m)
41 N
.
m
(4.1 kgf-m)
88 N
.
m
(8.8 kgf-m)
The drive chain joint clip should be attached in the
way that the slit end will face opposite to the direction
of travel.
To Next Page
Loading...
