CHASSIS 5-31
• Remove the steering stem lower bearing
C.
• Remove the ignition switch
D using the special tools.
" 09930-11920: Torx bit JT40H
09930-11940: Bit holder
INSPECTION
Inspect the removed parts for the following abnormalities. If any
damages are found, replace the respective parts with the new
ones.
* Steering race wear and brinelling
* Bearing wear or damage
* Abnormal bearing noise
* Distortion of steering stem or handlebars
• Remove the steering stem lower inner race, use a chisel.
!
• Drive out the steering stem upper and lower bearing races by
using the special tools.
" 09941-54911: Bearing outer race remover
09941-74911: Steering bearing remover
* Unless corrosion, damage or other abnormal condi-
tion is found, the bearing race need not be replaced.
* Once the lower inner race has been removed,
replace it with a new one.
To Next Page
Loading...
