5-24 CHASSIS
REASSEMBLY AND REMOUNTING
Reassemble and remount the front fork in the reverse order of
removal and disassembly. Pay attention to the following points:
!
• Insert the oil lock piece
1 into the inner tube and install the
oil seal
2.
NOTE:
Apply grease to the oil seal
2 lip lightly before installing it.
% 99000-25010: SUZUKI SUPER GREASE “A”
NOTE:
* When installing the oil lock piece, insert the tapered end
A of
oil lock piece into the inner tube.
* When inserting the inner tube into the outer tube, take care not
to come off the oil lock piece from the inner tube.
OIL SEAL
• Apply fork oil to the lip of the oil seal
1 and install it into the
outer tube using the front fork oil seal installer.
"
""
" 09940-52861: Front fork oil seal installer set
!
* Thoroughly wash all the component parts being
assembled.
* When reassembling the front fork, use new fork oil.
* Use the specified fork oil for the front fork.
* When reassembling, replace the oil seal, dust seal
and damper rod bolt gasket with new ones.
Wash clean the front fork oil seal installer before
using. If dirt is on the installer, the inner tube may pos-
sibly be damaged during press-fitting work.
To Next Page
Loading...
