3-22 ENGINE
ROCKER ARM I.D.
Measure the inside diameter of the rocker arm and check the
wear of the camshaft contacting surface.
$ Rocker arm I.D.
Standard
(IN. & EX.): 12.000 – 12.018 mm
% 09900-20605: Dial calipers
REASSEMBLY
Reassemble the cylinder head cover in the reverse order of dis-
assembly. Pay attention to the following points:
• Apply engine oil to the rocker arm shafts.
• Install the rocker arms
1, wave washers
2 and shafts
3.
"
• Tighten the rocker arm shaft bolts to the specified torque.
# Rocker arm shaft bolt: 9 N·m (0.9 kgf-m)
"
Use the new O-rings
A to prevent oil leakage.
Install the gasket washer to the bolts
B.
To Next Page
Loading...
