CHASSIS 5-37
REAR SPROCKET
• Tighten the sprocket mounting nuts to the specified torque.
'-Rear sprocket mounting nut: 60 N·m (6.0 kgf-m)
NOTE:
The stamped mark
A on the rear sprocket should face to the
outside.
REAR WHEEL
• Align the brake panel stopper
1 on the swingarm with the
recess on the brake panel.
• Install the rear axle shaft.
• Adjust the drive chain slack after installing the rear wheel.
(#2-12)
• Tighten the rear axle nut
2 to the specified torque.
' Rear axle nut: 65 N·m (6.5 kgf-m)
• Tighten both chain adjusters
3 securely.
• Adjust the rear brake pedal free travel. (#2-16)
Clearance
To Next Page
Loading...
