5-52 CHASSIS
• In this condition, check the “rim line” cast on the tire side
walls. The line must be equidistant from the wheel rim all
around. If the distance between the rim line and wheel rim
varies, this indicates that the bead is not properly seated. If
this is the case, deflate the tire completely and unseat the
bead for both sides. Coat the bead with lubricant and fit the
tire again.
• When the bead has been fitted properly, adjust the pressure
to specification.
• As necessary, adjust the tire balance.
(
$ Tire pressure
Solo riding and Dual riding:
Front: 125 kPa (1.25 kgf/cm
2
)
Rear: 125 kPa (1.25 kgf/cm
2
)
* After mending a puncture of the tire, do not travel
with that tire at a speed of more than 50 km/h at least
for 24 hours after mending.
* Do not run with a repaired tire at a high speed.
Rim line
To Next Page
Loading...
