ENGINE 3-27
VALVE SEAT SERVICE
The valve seats for both intake and exhaust valves are
machined to two different angles. (The seat contact surface is
cut at 45°.)
% 09916-20620: Valve seat cutter (N-122)
09916-21111: Valve seat cutter set
09916-24480: Solid pivot (N-140-5.5)
09916-24920: Valve seat cutter (N-212)
NOTE:
Use the solid pilot (N-140-5.5) along with the valve seat cutter
(N-121, -122 and -212)
"
• When installing the solid pilot
1, rotate it slightly.
• Seat the pilot snugly. Install the 45° cutter
2, attachment
3
and T-handle
4.
INTAKE SIDE EXHAUST SIDE
15° N-212 15° N-121
45° N-122 45° N-122
45˚
15˚
Valve seat
The valve seat contact area must be inspected after
each cut.
15˚
15˚
45˚
45˚
To Next Page
Loading...
