10. ALTERNATOR/STARTING CLUTCH
10-7
One way clutch Installation
Install the components in the reverse procedures
of removal.
Caution
Tape a tightening tape onto the thread of hexagon
bolt.
Torque value: 1.0~1.4kgf-m
Install starting driven gear.
Flywheel Installation
Align the key on crankshaft with the flywheel
groove, and then install the flywheel.
Hold the flywheel by drive face with universal
holder, and tighten flywheel nut.
Torque value: 5.0~6.0kgf-m
Special tool:
Universal Holder
To this chapter contents
Groove
3 socket bolts
Starting driven gear
To Next Page
Loading...
