2. MAINTENANCE INFORMATION
2-9
Chain Propulsion System
Check the drive chain
Park the ATV on a level ground, and shift the
transmission onto neutral.
Measure the drive chain slack midway between
the sprockets.
Chain slack: 15~25mm (5/8~1 inch)
Adjust the chain slack
Loosen the axle holder lock bolts and turn drive
chain adjusting nuts until get the correct slack.
Tighten the axle holder bolts.
Torque: 3.25kgf-m
Caution
y This type ATV has a chain tensioner to
adjust and protect drive chain.
4 bolts
Adjustment nut
Tensioner
To Next Page
Loading...
