To this chapter contents
2. MAINTENANCE INFORMATION
Brake Lining Wear
2-11
The indent mark on brake lining is the wear
limitation.
Replace the brake lining if the wear limit mark
closed to the edge of brake disc.
Caution
y To check front brake lining must be remove
front wheel first.
y It is not necessary to remove brake hose when
replacing the brake lining.
Brake Lining Replacement (refer chapter
14)
Make sure the brake lining condition. Replace
the lining if the brake lining wear limitation groove
close to the brake disc.
Caution
y Do not operate the brake lever after the clipper
removed to avoid clipping the brake lining.
y In order to maintain brake power balance, the
brake lining must be replaced with one set.
Brake Light Switch/Starting Inhibitor
Switch
The brake light switch is to light up brake light as
brake applied.
Make sure that electrical starter can be operated
only under brake applying.
Brake lining wear
limitation groove
Rear brake
Lining
Brake disk
Brake lining wear
limitation groove
Front brake
Brake switch
Brake switch
To Next Page
Loading...
