To this chapter contents
1. GENERAL INFORMATION
E. Clutch, driving and driving pulley
1-17
F. Poor handling
y Clutch weights spring broken
y Clutch outer stuck with clutch weights
y Connection parts in clutch and shaft worn out or burned
Engine can be started but
motorcycle can not be moved.
FAULT CONDITIONS
PROBABLE CAUSES
y Drive belt worn out or deformation
y Ramp plate of movable drive face damaged
y Driving pulley spring broken
y Clutch weights broken
y Drive slide-shaft gear groove broken
y Transmission gear damaged
Engine running and misfire as
motorcycle initial forward moving or
jumping suddenly (rear wheel
rotating as engine in running)
Poor initial driving (Poor climbing
performance)
y Drive belt worn out or deformation
y Weight roller worn out
y Movable drive face shaft worn out
y Driven pulley spring deformation
y Driven pulley shaft worn out
y Greased in drive belt and driven face.
Steering is heavy
FAULT CONDITIONS
PROBABLE CAUSES
y Damaged steering bearing
y Damaged steering shaft bushing
y Bent rim
y Improperly installed wheel hub
y Excessive wheel bearing play
y Bent swing arm
y Bent frame
y Swing arm pivot bushing excessively
y Worn
One wheel is wobbling
y Bent tie-rod
y Incorrect tie-rod adjustment
y Rear tie air pressure incorrect
y Improper wheel alignment
y Bent frame
Vehicle pulls to one side
To Next Page
Loading...
