SYSMEX CyFlow Cube 6 V2m - 3.2 Components of the Device

3 Overview
18
CyFlow™ Cube 6 V2m | Operating Manual | February 2020
Figure 4: Sample port at the right side of the device
#
Item
#
Item
1
Start electrode
4
Sample holder
2
Stop electrode
5
Sample port injection needle
3
Sample tube
3.2 Components of the device
The device contains the flow cuvette, the optics, the fluidics, the computer unit and data
acquisition electronics. No work steps inside the device are necessary.
The main components of the device are:
3.2.1 Control elements
The device is operated via keyboard and mouse. The On switch is located on the top,
when the display of the device is lifted up. The power switch is located on the rear side of
the device.
3.2.2 Computer interface ports
The computer interface ports connect the device with additional optional electronic
devices. They are located on the left side of the device.
3.2.3 Sheath Fluid and Waste bottle
The Sheath Fluid transports the sample flow during the measurement. The connecting
ports for the Tubing of the Sheath Fluid bottle and Waste bottle are located on the rear
side of the device. The Sheath Fluid bottle and Waste bottle are located next to the
device.