Systema EOLO BC RT - Warranty; Object and Duration of the Warrant; Warranty Exclusions; Effectiveness and Effectiveness of the Warranty

82
10
SYSTEMA EOLO RT rev. 09ENIT04052021
GARANZIA
10 WARRANTY
10.1 OBJECT AND DURATION OF THE WARRANT
1) The Warranty is limited to defects in material or workmanship of the components supplied by SYSTEMA.
In the event of defects in material or workmanship, SYSTEMA will repair or replace the defective parts
free of charge, EXPRESSLY EXCLUDING ANY OTHER FORM OF WARRANTY OR INDEMNITY, BOTH
LEGAL OR CONVENTIONAL.
The replaced parts will be promptly returned to SYSTEMA, ex its factory in Zdunska Wola - Poland, at the
user's expense and expense.
In the event of an intervention under Warranty, the user will be responsible for the xed right of call, in addition
to the kilometer reimbursement, if the place of intervention is more than ten kilometers from the CA (As-
sistance Center) headquarters.
2) The validity of the Guarantee starts from the “Start-up”, provided that it occurs within 6 (six) months from
the date of purchase of the appliance by the purchaser. In any case, the Guarantee expires after 18 (ei-
ghteen) months from the SYSTEMA invoice date.
3) Any replacement of defective parts (or of the entire appliance), it will not extend the original term of expiry
of the Guarantee. The Warranty on the replaced parts will cease with the expiration date of the Appliance
Warranty.
4) The “warranty duration” will be 1 (one) years on each component of the appliance
10.2 WARRANTY EXCLUSIONS
1) The Guarantee does not operate in the case of:
a) defects not attributable to defects in material or workmanship, without limitation:
- breakages occurred during transport;
- non-compliance of the system with local laws and regulations in force;
- failure to comply with the installation specications indicated in the technical notes supplied with the Ap-
pliance and / or with the rules of good practice;
- damage caused by accidents, re, accidents in general or negligence not attributable to SYSTEMA;
b) tampering or failures due to interventions by unauthorized personnel;
c) defects caused by anomalies depending on the electrical or fuel supply network;
d) failures due to: poor maintenance, neglect or improper use, voltage variations in the power supply, humi-
dity and dust in the premises, incorrect sizing and / or faulty installation;
e) corrosion or breakage caused by: stray currents, condensation, overheating caused by incorrect regu-
lation of the gas pressures in the supply or to the burner, or by the use of combustible gas with caloric
characteristics di󰀨erent from those indicated on the plate;
f) use of non-original spare parts or those not authorized by SYSTEMA;
g) normal wear and tear;
h) products not properly guarded or stored.
10.3 EFFECTIVENESS AND EFFECTIVENESS OF THE WARRANTY
1) In order to make the guarantee e󰀨ective and e󰀨ective, the user must:
a) ask your installer for the name of the CA for the "First start-up";
b) show the Certicate of Guarantee to the personnel in charge, complete it in its entirety and request
the stamping and signature of the CA in the appropriate spaces.
10.4 RESPONSIBILITY
The customer releases the supplier from any liability for accidents or damage that may occur to machines
or systems during operation. The supplier is liable to the buyer only within the limits of the aforementioned
warranty obligations.