TallyGenicom MATRIX PRINTER 2150 - List of Available Control Codes

➤ List of available control
codes
The following table shows sequences marked by a ✓ if they are available
in the various emulations. The MTPL sequences can be used within all
emulation modes. The corresponding sequences are marked by a ✽.
If you want to know more about control codes, we recommend our
Programmer’s Application Manual on this CD-ROM .
MTPL
IBM
XL24e
IBM
AGM
Epson
LQ-2550
Epson
LQ-2170
Code Function
✓✓ ✓✓
<BEL> Signal tone
✓✓✓✓✓
<BS> Control character BS (Backspace)
✓✓
<CAN> Deleting a data line
✓✓✓✓✓
<CR> Control character CR (Carriage return)
✓
<CSI> Start character for MTPL sequences, corr. ESC [
✓✓
<DC1> Selecting the printer
✓✓
<DC2> Condensed printing OFF (set by <Sl> or <ESC><Sl>)
✓✓
<DC3> Deselecting the printer
✓✓
<DC4> Double-wide printing OFF (set by <SO> or <ESC><SO>)
✓✓✽✓✓
<DEL> Delete line. Epson: Delete last character
✓✓✓✓✓
<ESC> Start character for programming sequence
✓✓✓✓
<ESC>!<n> Print mode selection
✓✓✓
<ESC># Bit 8 = unchanged
BACK
QUIT
?
PRINT
Reference manual Emulations
118