Parameter group Parameter
Description
CPI 5 CPI, 6 CPI,
7.5 CPI, 8.6 CPI,
10 CPI*, 12 CPI,
15 CPI, 17.1 CPI,
20 CPI
Sets the characters per inch (character pitch). The higher the parameter the
smaller the character spacing.
LPI 2 LPI, 3 LPI, 4 LPI
6 LPI*, 8 LPI,
12 LPI
Sets the lines per inch (line density). The higher the parameter the smaller
the line spacing. Random LPI can be selected via the ESC sequences.
Skip Skip = 0.0 Inch*
Skip = 0.5 Inch
Skip = 1.0 Inch
Skip = 1.5 Inch
Skip = 2.0 Inch
Skip = 2.5 Inch
Skip = 3.0 Inch
Skip = 3.5 Inch
Skips the perforation; 7 different values (in inches) can be defined.
ESCChar ESCChar = ESC*
ESCChar = ESC+$$
Selects the start signal for control sequences: Escape signal only or Escape
signal and two $ signs. A description can be found in the chapter
Emulations
.
Emulate Epson LQ-2550*
Epson LQ-2170
IBM Propr. XL24e
IBM ProXL24e+AGM
MTPL
Selects the emulation. MTPL is also active in IBM or Epson emulation mode.
BACK
QUIT
?
PRINT
Reference manual The Menu
56
To Next Page
Loading...
