3-2
SECTION 3
Maintenance Guidelines
n Allow only qualified and authorized personnel are to maintain, repair,
adjust, and inspect the vehicle.
n Before starting any repairs or maintenance, immobilize the vehicle by
turning the key switch off, removing the key, and setting the park brake.
n Disconnect both of the main battery leads before working on or
disconnecting any electrical component or wire.
n Block the chassis with jack stands before working under a raised
vehicle.
n Conduct vehicle performance checks in an authorized area where safe
clearance exists.
n Before starting the vehicle, follow the recommended safety procedures
in Section 2, “Safety Rules and Operational Information.”
n Avoid fire hazards and have fire protection equipment present in the
work area. Do not use an open flame to check level or leakage of battery
electrolyte. Do not use open pans of fuel or flammable fluids for cleaning parts.
n Ventilate the work area properly.
n Regularly inspect and maintain in a safe working condition, brakes,
steering mechanisms, speed and directional control mechanisms, warning
devices, lights, governors, guards, and safety devices.
Introduction to Maintenance
This section contains the procedures necessary to repair and service your vehicle.
You will also find periodic maintenance information and guidelines to follow before
doing any kind of maintenance or service on this vehicle. Vehicle maintenance or
repairs should only be performed by a qualified mechanic.
This section contains the following:
n Maintenance Guidelines
n Maintenance Guidelines for Vehicles Used in Severe Conditions
n Maintenance Checklist
n Lubrication Chart
n Troubleshooting Guide
n Detailed Maintenance Procedures.
To Next Page
Loading...
