3-33
Removing the MX-600 Rear End Assembly
Here, we are referring to the complete assembly including wheels, axle, housing,
drive, and drive motor. In order to remove this complete assembly from the vehicle,
use the following procedure:
1. Park the vehicle on a clean level surface.
2. Dissconnect the batteries
3. Lift the front of the vehicle and place blocks under the frame.
4. Lower the front of the vehicle onto jack stands.
5. Raise the rear of the vehicle and support it with jack stands.
NOTE: You may want to remove the tires in order to make it easier to
remove the mounting bolts from the frame.
6. Place another set of jack stands under the drive assembly, and remove
the bolts mounting the drive assembly to the frame.
7. Lower the entire rear end assembly.
8. Disconnect the brake cables.
9. Disconnect the wires from the motor
10. Remove the rear end assembly from under the vehicle.
10. Install in reverse order.
Complete MX-600 Drive and Rear End Assembly
Always use a lifting strap, hoist and jack stands of adequate
capacity to lift and support the vehicle. Failure to use lifting and
supporting devices of rated load capacity to support the vehicle
may result in serious injury and property damage.
To Next Page
Loading...
