3-12
SECTION 3
Removing the Brake Assembly
In order to remove the brake assembly refer to the following instructions:
1. Park the vehicle on a level surface and block the tires to prevent any
accidental movement.
2. Remove the key and place the forward/reverse switch in the neutral
position.
3. Remove the deck board and seat from the vehicle.
4. Remove the spring from the lever bar.
5. Remove the cotter pin and the clevis pin from the brake band.
6. Remove the brake band anchor bolt and brake band.
7. Remove the brake drum from the pinion shaft.
8. Clean and inspect the brake band and brake drum. Replace all worn
parts as needed.
NOTE: If the brake lining or pad is 1/16” or less in thickness,
the lining must be replaced. Also, if the brake drum is severely
scored, damaged, or less than 5.85” in diameter it must be
replaced with a new brake drum.
NOTE: If the brake drum is glazed or lightly scored. The
glazing or scoring should be removed from the drum by
sanding.
9. Reinstall the brake assembly by doing steps 1 through 7 in reverse
order.
10. Adjust the brake band.
To Next Page
Loading...
