ALGORITHMS
M5DYN
Rev 1.1 Page 2
Normally, you do not have to change the
factory default setting.
OUTLEV off - 0.0 dB. Sets the output level of the algorithm in
0.5 dB steps. The function of this control
is to maximize dynamic range by
allowing the ambience algorithm to
output maximum signal to the DA
converters. It affects the output PPM
reading. There is a separate output level
control for adjusting the analog output
level in UTIL. Set the analog input (if
you use analog input) and the INLEV
adjustments before setting this control.
The control does not affect the bypassed
signal level. Normally, you do not have
to change the factory default setting.
SHAPE Room/Hall simulation/equivalent. With
this control the initial pattern is chosen.
Six distinctively different room shapes
are available:
HALL
The HALL reflection pattern is based on
the acoustic properties of the
Boston
Symphony Hall, USA.
FAN
The FAN pattern is based on the
La
Scala Concert Hall in Milan, Italy.
PRISM
The PRISM pattern is from acoustic
designers '
Golden Ratio
' shoe box
shaped Hall.
H.SHOE
The Horseshoe shaped pattern is based
on the
Musikvereinssaal, Austria.
CLUB
The CLUB pattern is based on the
typical dimensions of a club-sized
location.
SMALL
The SMALL pattern is an artificially
made, relatively small room. The room
has been reworked to minimize some of
the unfortunate coloring artifacts that
would otherwise have dominated a room
of this size.
x SIZE 0.040 - 4.000 Scales the dimensions of the simulated
space depending on the SHAPE chosen.
The specific room that is being simulated
is scaled 1:1 at SIZE =1.00. This can
then be scaled up or down (see table 1 in
To Next Page
Loading...
Need help?
General
