ALGORITHMS
M5AMBIEN
Rev 1.2 Page 25
fig. 7
L-RATIO off - infin:1 Gain reduction ratio.
L-ATTCK 30 µs - 10 ms Limiter attack time.
L-RLEAS 20 ms - 7.0 s Limiter release time.
FEEDFWD 0.0 ms - 25 ms Adjusts the Limiter sidechain delay time.
By slightly delaying the audio signal, the
limiter has ample time in which to create
the necessary level correction. To take
full advantage of the digital properties of
DYNAMIC1 this value should be equal
to or greater than the L-ATTCK value. If
faster processing is a priority this value
may be set to 0.0 ms and the limiter will
behave as a standard analog limiter. In
this case overshoot is not always
suppressed
NOTE: The NOM-DLY parameter (page
7) must always be set equal to or greater
than the FEEDFWD parameter found in
the LIMITER or COMPRESSOR which
ever is higher.
PAGE 6 - EXPANDER:
E-THRSH -94 dB - 1.5 dB Expander threshold.
E-RATIO off - 1:infin Expander ratio.
E-ATTCK 0.3 - 100 ms Expander attack time.
E-RLEAS 20 ms - 7.0 s Expander release time.
E-RANGE -40.0 dB - 0.0 dB Expander range.
PAGE 7:
PAR-LNK off - on Links the parameters found on any given
PAGE (except '0dB ref' and METER on
page 3, which always are linked) to each
other in order to have common control of
the bands. With LINK
on
any of the
parameters can be adjusted and the two
other bands will follow.
To Next Page
Loading...
