1.1.5 Maintenance precautions (while working)
(1) Follow the specied work procedure.
(2) Do not remove any covers or components other than those necessary
to do the job.
(3) Do not allow people other than service personnel to enter the work
area.
Do not speak to service personnel while they are working.
(4) When working in a group, pay attention to the safety of your fellow
worker(s) as well as to your own safety. Do not try to perform tasks
other than the ones specied in advance.
(5) Sound an alarm immediately if you notice a danger.
(6) Do not toss tools or parts to a fellow worker. Hand them over with
care.
(7) When leaving the equipment unattended during maintenance, turn it
off.
If the power fails, turn off the power switch on the equipment. For
example,
• Lower any raised load to the ground
• Turn off the switch to any power tools, such as drills, grinders or
welders.
(8) Do not use unstable objects, such as a box or a component, as a step-
ladder.
(9) Do not spill oil or grease on the floor. Wipe up any spilled oil or
grease on the oor right away.
(10) Clean the oil ll ports and grease ttings before adding oil or grease.
(11) Lubrication and oil level checks should always be performed with the
truck parked on a level surface.
(12) Do not stand or walk under raised forks, buckets or hoists.
When using a jack or hoist, do not exceed its rated capacity.
Always keep safety in mind when servicing the machine.
Work procedure
Do not speak!
To Next Page
Loading...
