1.1.6 Maintenance precautions (after servicing)
(1) Clean the equipment and tools.
(2) After servicing, return the work bench, truck carriage, tools and pallets
to their designated positions.
(3) Wipe up any contaminants, spilled oil or grease in the work area.
(4) Discard waste such as waste oil, used waste cloth, and glass at the
specied place.
You should always have in mind that the environment must be
protected.
(5) Neutralize any spilt battery electrolyte with sodium bicarbonate or
wash it away with a large amount of water.
(6) Make certain all the switches on the electrical equipment you used
have been turned off.
(7) Use only TCM approved replacement parts and lubricants.
(8) After servicing, make sure the truck operates properly.
1.1.7 Modications to the truck might void your warranty
Do not try to modify your truck. Modifications to your truck which
affect the performance, safety or strength of the truck might cause an
accident and will void your warranty as well.
1.1.8 When working in an elevated place
If you need to work in an elevated place, refer to the “Safety Instructions
for Working in Elevated Locations.”
1.1.9 When working in a group
(1) Pick a group leader.
(2) Make sure everyone understands the meaning of any hand signals and
the communication methods that will be used.
(3) Work in an orderly manner that is specied in advance.
(4) Lift heavy loads as a group of two or more or using mechanical aids.
Put a support on the ground before lowering the load to prevent your
hands from getting pinched.
(5) Before moving a load handling lever, sit down properly in the
operator’s seat and make sure all your fellow workers know you are
going to move the loading system.
No!
Weight
Support
Good
To Next Page
Loading...
