3-70
Fig. 3.223
Fig. 3.225
Fig. 3.224
④ Install the hub assembly (1) on the drive axle,
making sure that the identification mark (or
number) on the inner tapered roller bearing
cup in the hub assembly is the same as that
on the inner tapered roller bearing cone at the
drive axle side.
⑤ Install the adjustment nut (1) and then adjust
the hub starting torque.
⑥ Install the lock washer (1) and lock nut (2).
Secure the lock nut (2) using the lock washer
(1) tabs.
To Next Page
Loading...
