3-86
Fig. 3.271
Fig. 3.274
Fig. 3.273
Fig. 3.272
■REASSEMBLY
① Reassemble the wheel cylinder as follows:
● Applybrakefluidonthe pistoncup(1)and
piston (2).
● Insertthespring(3),pistoncup(1),back-up
ring (4), and piston (2) into the cylinder in
that order.
● Installthedustcover(5)andpushrod(6)to
each side of the cylinder.
② Install the backing plate (1) to the drive axle
(3) with eight bolts (2).
274 - 323 N-m {30.0 - 33.0 kgf-m}
[202.1 - 238.2 lbf-ft]
③ Install the wheel cylinder (1) to the backing
plate (3) with two bolts (2).
17.7 - 26.5 N-m {1.8 - 2.7 kgf-m}
[13.1 - 19.5 lbf-ft]
④ Apply heat-resisting grease to the following
areas (shown in Figure 3.274):
Note: Use caution not to contaminate the lining
with grease.
(a) Backing plate in shoe contact area
(b) Anchor pin
(c) Parking brake lever pin
(d) Adjuster threads and other rotating parts
To Next Page
Loading...
