TECAN
2. General
2006-03 Instructions for Use for sunrise Absorbance Reader No. 30008746 Rev. No. 1.4 2-19
2.6.2 Microplate Shaking
The sunrise is able to shake the microplate before it is measured. Use external
software (for example: Magellan) to set the shaking modes.
The microplate can also be shaken between each of the kinetic measurement
cycles.
WARNING
WHEN USING A 96 WELL PLATE IN HIGH SHAKE MODE, SPILLAGE
MAY OCCUR IF THE WELLS ARE FILLED WITH MORE THAN 300 µL.
The shaking widths and frequencies for the 4 sunrise shake modes are as
follows:
Shake Mode Shake Width Shake Frequency
HIGH
NORMAL
LOW
WIDE
2.8 mm
4.4 mm
4.4 mm
14.2 mm
12.3 Hz
9.2 Hz
7.8 Hz
2 Hz
2.7 Instrument Accessories
The table below contains the order numbers for instrument accessories:
Part Name Article Number
Halogen Lamp...........................................................................................13709008
Reader to External Computer Cable ........................................................13350005
QC Pac 1 for
sunrise ...............................................................................10037371
QC Pac 2 for
sunrise ...............................................................................10037372
Additional Filter Slide (Standard 4-Filter)..................................................30004215
Additional Filter Slide (6-Filter)..................................................................10036319
TS - Pen....................................................................................................11106542
Barcode Upgrade Kit.................................................................................30000322
Note
Please contact your local distributor for available USB sticks.
To Next Page
Loading...
