3. Installation Procedure
TECAN
3-4 Instructions for Use for sunrise Absorbance Reader No. 30008746 Rev. No. 1.4 2006-03
3.8 Defining the Instrument Settings
This program enables the user to define the settings of:
• Instrument modes
• Filter definition
• Measurement modes
Caution
If used in the IVD environment, only the authorized person is allowed to
change and define the “Sunrise Instrument Settings”.
3.8.1 Installation of “Sunrise Instrument Settings” Software
The “Sunrise Instrument Settings” software is installed using the following
procedure:
1. Insert Tecan Detection Suite CD into the required CD ROM drive.
2. The setup dialog box is displayed. Click the service and settings button.
Click the setup button for the “Sunrise Instrument Settings”. The installation
program is started, which installs “Sunrise Instrument Settings” onto your
computer
3. A series of dialog boxes will appear, read each one, enter any necessary
information and click Next to continue.
4. The files are then installed and the program icon is created.
5. When the Installation Complete dialog box appears, click Finish and the
“Sunrise Instrument Settings”
program is ready to be used.
To Next Page
Loading...
