TECAN
4. The sunrise Touchscreen
2006-03 Instructions for Use for sunrise Absorbance Reader No. 30008746 Rev. No. 1.4 4-1
4. The sunrise Touchscreen
4.1 Introduction
The sunrise Touchscreen option consists of:
• A screen that includes a touch panel
• A Touchscreen pen
• Operating software MagellanCE
• A USB stick
The Touchscreen option enables the user to control the reader and evaluates
obtained data, using the onboard software. The WindowsCE™ based software,
MagellanCE, offers the user the possibility for full instrument control, data
reduction and storage. Enhanced curve fitting and screening tools, as well as the
possibility to combine several assays on one plate, makes it an ideal tool for
various laboratory purposes. The Touchscreen offers a clear and easy overview
of all available data.
The MagellanCE provides the user with Wizards for all operating procedures and
guides the user through the software program via step-by-step commands.
Disclaimer
Magellan has been carefully revised and checked. With the exception of
negligence or intention, Tecan takes no liability for any damages that
occur as a result of the software.
Caution
If the instructions given in this manual are not correctly performed, the
instrument may be damaged or the procedure may not be correctly
performed and the safety of the instrument cannot be guaranteed.
Caution
Before the instrument is installed and switched on, it should be left to
stand for at least three hours, so there is no possibility of condensation
causing a short circuit.
Caution
Before starting measurements, make sure that the microplate position
A1 is inserted correctly.
™ Windows is registered trademark of the Microsoft Corporation.
To Next Page
Loading...
