TECAN
5. Error Messages and Trouble Shooting
2006-03 Instructions for Use for sunrise Absorbance Reader No. 30008746 Rev. No. 1.4 5-1
5. Error Messages and Trouble
Shooting
5.1 Introduction
The internal microprocessor controls and checks all electronic functions as well
as measurements, operations and results. If the microprocessor detects a fault or
an incorrect operating procedure, an error message is displayed on the computer.
5.1.1 Table of Error Messages and Trouble Shooting for
sunrise Mode
The following table gives a brief description of the error messages and the trouble
shooting actions.
Note
If other error messages appear that are not mentioned in the table below,
contact your local service engineer.
Error Message Description Trouble Shooting
System Error
Out of memory in module… Internal firmware error Switch instrument off and then on
again. Contact your local service
engineer, if the error continues.
Not implemented Internal firmware error Switch instrument off and then on
again. Contact your local service
engineer, if the error continues.
Timer event not active Internal firmware error Switch instrument off and then on
again. Contact your local service
engineer, if the error continues.
To Next Page
Loading...
