10 TEGAM WAY • GENEVA, OHIO 44041 • 440-466-6100 • FAX 440-466-6110 • sales@tegam.com
4-4
DISPLAY MODES
When the power key is depressed, AC power is applied to the 1750. During the power cycle, the
1750 operating system initiates and the display will show the product identification information. The
1750 digital software revisions appear below the product identification. This display will be visible for
about two seconds and then the 1750 will resume operation under the same set-up parameters as
when it was last turned off.
Figure 4.3: Initialization Display
After initialization, the 1750 microohmmeter will display one of three types of displays, Resistance,
Absolute Comparator, or % Comparator. The particular display mode will be dependent upon the
mode that the 1750 was operating in before the last power down. The following sections will describe
each of the display modes and their respective display fields.
Tegam Model 1750
Revision 2.XX
To Next Page
Loading...
