Tektronix TG8000 Programmer's Manual

GPS7 GPS Synchronization and Timecode module remote commands
Sets the time so
urce for leap second adjustment. If UTC is selected, a leap
second will be applied at 00:00:00 UTC. If the source is set to local, you can
specify the time to apply the leap second adjustment.
:SOURce:TIMESet:LEAPsec:S OURce?
Returns the
time source for the leap second adjustment.
:SOURce:TIMESet:LEAPsec:T IME
<numeric_v
alue>,<numeric_value>,<numer ic_value> (HH:MM:SS)
Sets the local time when a leap second will be added. The source must be
set to LOCa
l for this setting to apply.
:SOURce:TIMESet:LEAPsec:T IME?
Returns the time setting when a leap second will be applied.
:SOURce:TIMESet:ALARm:STA Te 0 | 1
Enables and disables the alarm timer. The alarm timer is used to the GPI
ground closure. This feature can be used to drive a tally light or similar
indicator at a specific time in a program.
:SOURce:TIMESet:ALARm:STA Te?
Returns the enabled/disabled state of the alarm timer.
:SOURce:TIMESet:ALARm:TIM E
<numeric_value>,<numeric_ value>,<numeric_value> (HH:MM:SS)
Sets the time at which the alarm timer triggers a GPI ground closure.
:SO
URce:TIMESet:ALARm:TIME?
Returns the time at which the alarm timer is set to trigger a GPI ground
cl
osure.
:SOURce:TIMESet:LLOSs:GPO :MDELay
<
numeric_value>,<numeric_valu e>,<numeric_value> (HH:MM:SS)
Sets a delay time for the GPI alarm to report a loss of lock condition.
:SOURce:TIMESet:LLOSs:GPO :MDELay?
Returns the delay time for the GPI alarm to report a loss of lock condition.
:SOURce:TIMESet:LLOSs:BLA ck:MDELay
<numeric_value>,<numeric_ value>,<numeric_value> (HH:MM:SS)
Sets a delay time for the black2 output to be blanked on loss of lock.
:SOURce:TIMESet:LLOSs:BLA ck:MDELay?
Returns the delay time setting for blanking the black2 output on loss of lock.
Draft
88 TG8000 Multiformat Test Signal Generator Programmer Manual

Tektronix TG8000 Specifications

General

Brand	Tektronix
Model	TG8000
Category	Portable Generator
Language	English