To Next Page

To Previous Page

GPS7 GPS Synchronization and Timecode module remote commands

Week Number: FI

RST / SECOND / THIRD / FOURTH / LAST

Week Day: SUN / MON / TUE / WED / THU / FRI / SAT

Month:JAN/FEB/MAR/APR/MAY/JUN/JUL/AUG/SEP/OCT/

NOV / DEC

:SOURce:TIMESet:AUTO:STIME <n umeric_value>, <numeric_value>,

<numeric_value> (HH:MM:SS)

Sets the time when the DST offset value is to be applied when the

AUTO:STATE is set to the RECUR mode.

:SOURce:TIMESet:AUTO:ETIME <n umeric_value>, <numeric_value>,

<numeric_value> (HH:MM:SS)

Sets the date when the DST offset value is to be removed when the

AUTO:STATE is set to

the RECUR mode.

:SOURce:TIMESet:PCOUnter:I NITialize

Sets the global program counter. Any module output (GPS7, BG7, or

HDVG7) that can put timecode on the video signal can be conﬁgured to use

the Program Time counter as its source. This is a set only command.

:SOURce:TIMESet:PCOUnter:T IME:INITial

<numeric_value>,<numeric_v alue>,<numeric_value> (HH:MM:SS)

Sets the time for the program counter.

:SOURce:TIMESet:PCOUnter:T IME:INITial?

Returns the program counter initial time setting.

:SOURce:TIMESet:JAMSync:ST ATe 0 | 1

Sets the timecode jam sync state. A setting of 1 enables automatic jam sync

at the speciﬁed time.

:SOURce:TIMESet:JAMSync:ST ATe?

Returns the timecode auto jam sync state. A returned value of 1 means auto

jam sync is enabled. A returned value of 0 means auto jam sync is disable d.

:SOURce:TIMESet:JAMSync:EX ECute

Immediately initiates a jam sync. This is a set-only command.

:SOURce:TIMESet:JAMSync:TI ME

<numeric_value>,<numeric_v alue>,<numeric_value> (HH:MM:SS)

Sets the time when an automated jam sync should o ccur.

:SOURce:TIMESet:JAMSync:TI ME?

Returns the time when a n automatic jam sync is set to occur.

:SOURce:TIMESet:LEAPsec:SO URce LOCal | UTC

Draft

TG8000 Multiformat Test Signal Generator Programmer Manual 87

Tektronix TG8000 Programmer's Manual

Other manuals for Tektronix TG8000