HD3G7 3 Gb/s SDI Video Generator module remote commands
:OUTPut1:ANC:
UDW:INDex <NR1> {0-254}
Sets the U ser Data Word (UDW) location.
:OUTPut1:ANC:UDW:INDex?
Returns the UDW location where the :SET command puts its value and
returns its value.
:OUTPut1:ANC:UDW:SET <NR1:IN DEX>,<NR2:UDW>
Sets the location for and value of a User Data Word. The SET command takes
two arguments - first one is the index and second one is the UDW value. The
index argument (NR1) specifies the location where the UDW value (NR2)
will be set. The UDW value should be in Hex (preceded by #H, as shown in
below).
When Parity is set to 8-bit ( Auto):
:OUTP1:ANC:UDW #HFE ()
When parity is set to 10 bits (Manual):
:OUTP1:ANC:UDW #H2FF
:OUTPut1:ANC:UDW:SET?
Returns the value of the UDW value from the location that was earlier s et by
the OUTP1:ANC:UDW:INDex command.
:OUTPut1:ANC:UDW:CLEAr
Clears the ancillary payload User Data Words values (setting them to 0x00).
:OUTPut1:ANC:CS:MANual <HEX>
Sets the ancillary payload checksum manually to the value specified. The
available range is 0x000 - 0x3FF in 10-bit edit mode.
:OUTPut1:ANC:CS:MANual?
Returns the value specified for the ancillary payload checksum.
:OUTPut1:ANC:CS:AUTO:STAT e 0|1
Enables or disables the automatic checksum calculation for the ancillary
payload user data words.
:OUTPut1:ANC:CS:AUTO:STAT e?
Returns the state of the automatic checksum calculation (enabled or disabled).
:OUTPut1:ANC:CS:AUTO?
Returns the automatically calculated checksum for the ancillary payload user
data words.
:OUTPut1:ANC:VCH <LUMA|CHRO>
Draft
106 TG8000 Multiformat Test Signal Generator Programmer Manual
To Next Page
Loading...
