Tektronix TG8000

HD3G7 3 Gb/s SDI Video Generator module remote commands
Sets the video c
hannel for the ancillary payload to either Luma or Chroma.
Luma is the default value.
:OUTPut1:ANC
:VCH?
Returns the video channel for the ancillary payload.
:OUTPut1:ANC:LOCation <LINKA| LINKB>
Sets the location for the ancillary payload.
:OUTPut1:ANC:LOCation?
Returns the location for the ancillary payload.
:OUTPut1
:ANC:FIELd <0|1|2>
This command is applicable for interlaced and segmented frame formats. This
command
sets the ancillary payload e ither on Field 1 or Field 2 or both on
Field 1 & 2. The meaning of the arguments is : 0 = Field 1, 1= Field 2, and
2= Both Field1 & 2.
The Line numbers where Field1 and Field2 payload data is inserted can be set
using the two arguments (ln1, ln2) in the OUTP1:ANC:LINe command.
:OUTPut1:ANC:FIELd
Retur
ns the field o n which the ancillary payload is set.
:OUTPut1:ANC:DATa?
Returns the ancillary data settings as a single block of data. Data is returned as
a sequence of integers, with parameters separated by commas. Data is returned
in t
he following order (line breaks are inserted here for ease of reading):
<Line1>,
<L
ine2>,
<Sample>,
<Video Channel>,
<Link Loc>,
<Parity>,
<Output Mode>,
<DID>,
<SDID>,
<CS>,
<Auto CS Selection>,
<Field Selection>
:OUTPut1:BLACk <0|1>
Sets the secondary output. If not set, the secondary output uses the same test
pattern as the primary output.
:OUTPut1:BLACk?
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual 107