Tektronix TG8000

HD3G7 3 Gb/s SDI Video Generator module remote commands
Returns the sec
ondary output setting
:OUTPut1:CONVert:STATe?
Returns the standard and sampling structure information for the current
conversion.
:OUTPut1:DHD <SIG_SIG|SIG_BL K|BLK_SIG>
Sets the 2xHD stream content. SIG_SIG sets the stream content to Test
Signal/Test Signal. SIG_BLK and BLK_SIG set the stream content to Test
Signal/Black and Black/Test Signal respectively.
:OUTPut1:DHD?
Returns the 2xHD stream content setting.
:OUTPut1:EAUDio:AGROup[n] :STATe 0|1
Enables or d isables embedded a ud io for Link A group n, where n=1-4.
:OUTPu
t1:EAUDio:AGROup[n]:STATe
Returns the status of embedded audio for Link A group 1-4.
:OUTPut1:EAUDio:AGROup[n] :SAMPLing <FRAM|NOFR|ASYN>
Sets the sampling alignment status bits in the audio signal of a specific
embedded audio group for the selected outputs. The choices are
FRAM (Frame), NOFR (Frame without Frame Number), and ASYNC
(Asy
nchronous). The [n] in the command represents the group number.
:OUTPut1:EAUDio:AGROup[n] :SAMPLing?
Returns the sampling alignment status bits in the audio signal of a specific
embedded audio group for the selected outputs.
:OUTPut1:EAUDio:AGROup[n] :CHANnel[x]:AMPLitude
<numeric_value>
Sets the amplitude of a s pecific audio channel. The numeric value can range
from -60 dBFS to 0 dBFS in 1 dBFS steps. The [n] in the command represents
the group number. The [x] in the command represents the channel number.
You can use any channel number from 1 through 4.
:OUTPut1:EAUDio:AGROup[n] :CHANnel[x]:AMPLitude?
Returns the amplitude of a specific audio channel. The [n] in the command
represents the group number. The [x] in the command represents the channel
number.
:OUTPut1:EAUDio:AGROup[n] :CHANnel[x]:FREQuency
<numeric_value>
Draft
108 TG8000 Multiformat Test Signal Generator Programmer Manual