HD3G7 3 Gb/s SDI Video Generator module remote commands
Sets the freque
ncy of a specific audio channel. The unit is Hertz. The choices
are 10.0 - 20000.0 in steps of 0.5, default = 1000. The <n> in the command
represents the channel number. You can use any channel number from 1
through 8.
:OUTPut1:EAUDio:AGROup[n]: CHANnel[x]:FREQuency?
Returns the frequency of a specific audio channel.
:OUTPut1:E
AUDio:AGROup[n]:CHANnel[x]:C LICk 0|1|2|3|4
Sets the audio click of a specific audio channel. The c hoices are 1 second to
4 seconds,
or off (0). When 1 to 4 is selected, the audio click becomes valid.
When audio click is valid, audio tone is turned off for 0.25 seconds around the
time o f the click. The <x> in the command represents the channel number.
You can use any channel number from 1 through 4.
:OUTPut1:EAUDio:AGROup[n]: CHANnel[x]:CLICk
Returns the audio click status of the specified audio channel.
:OUTPu
t1:EAUDio:AGROup[n]:CHANne l[x]:MODE
ACTive|INACtive|MUTE
Sets t
he mode of a specific audio channel. The choices are ACT (active),
INAC (inactive), and MUTE (muted).
:OUT
Put1:EAUDio:AGROup[n]:CHANne l[x]:MODE?
Returns the mode of a specific audio channel.
:OUTPut1:EAUDio:AGROup[n]: CHANnel[x]:ORIGin <string>
Sets the channel origin ID of up to four ASCII characters.
:OUTPut1:EAUDio:AGROup[n]: CHANnel[x]:ORIGin?
Returns the channel origin ID.
:
OUTPut1:EAUDio:BGROup[n]:STA Te 0|1
Enables or disables embedded audio for Link B group n, where n=1-4.
:OUTPut1:EAUDio:BGROup[n]: STATe?
Returns the status of embedded audio for Link B group 1-4.
:OUTPut1:EAUDio:BGROup[n]: SAMPLing <FRAM|NOFR|ASYN>
Sets the sampling alignment status b its in the audio signal o f a specific
embedded audio group for the selected outputs. The choices are
FRAM (Frame), NOFR (Frame without Frame Number), and ASYNC
(Asynchronous). The [n] in the command represents the group number.
:OUTPut1:EAUDio:BGROup[n]: SAMPLing?
Draft
TG8000 Multiformat Test Signal Generator Programmer Manual 109
To Next Page
Loading...
