SDI7 Dual Channel SD/HD/3G SDI Video Generator module remote commands
Sets the line nu
mber(s) of the user-defined a ncillary data packet for the
selected generator output. Two values are required; the first value is for the
Field 1 line number and the second value is for the Field 2 line number. For
non-interlaced formats, use the same line number for both values.
:OUTPut<1|2>:ANC:LINe?
Returns the line n umbers on which the user-defined ancillary data packet is
located.
:OUTPut<1|2>:ANC:SAMPle <NR1 >
Sets the starting sample number of the user-defined ancillary data packet for
the selected generator output. For example, a value of 1928 represents the
first sample of HANC data space for 1920 1080 formats.
:OUTPut<1|2>:ANC:SAMPle?
Returns the starting sample number where the user-defined ancillary data
packet is located.
:OUTPut<1|2>:ANC:DID <Hexade cimal>
Sets the D ata Identifier of the user-defined ancillary data packet for the
selected generator output. Valid 8-bit values are in the range #H00 to
#HFF, and valid 10-bit values are in the range from #H000 to #H3FF. The
ANC:PARITY setting determines whether 8-bit values or 10-bit values are
used.
:OUTPut<1|2>:ANC:DID?
Returns the Data Identifier value of the user-defined ancillary data packet.
:OUTPut<1|2>:ANC:SDID <Hexad ecimal>
Sets the Secondary D ata Identifier of the user-defined ancillary data packet
for the selected generator output. Valid 8-bit values are in the range #H00 to
#HFF, and valid 10-bit values are in the range from #H000 to #H3FF. The
ANC:PARITY setting determines whether 8-bit values or 10-bit values are
used. The SDID value is o nly used for Type 2 ancillary data, when the DID
is in the range from #H00 to #H7F.
:OUTPut<1|2>:ANC:SDID?
Returns the Secondary Data Identifier value of the user-defined ancillary
data packet.
:OUTPut<1|2>:ANC:DBN <Hexade ciaml>
Sets the Data Bl
ock Number of the user-defined ancillary data packet for
the selected generator output. Valid 8-bit values are in the range #H00 to
#HFF, and valid 10-bit values are in the range from #H000 to #H3FF. The
ANC:PARITY setting determines whether 8-bit values or 10-bit values are
used. The DBN v alue is only used for Type 1 ancillary data, when the DID
is in the range from # H80 to #HFF.
Draft
154 TG8000 Multiformat Test Signal Generator Programmer Manual
To Next Page
Loading...
Need help?
General
