SDI7 Dual Channel SD/HD/3G SDI Video Generator module remote commands
Enables or disa
bles the audio/video timing m ode for the specified generator
output. Refer to the SDI7 module section in the TG8000 User Manual for
detailed information about this mode.
:OUTPut<1|2>:VIDeo:AVTimi ng:STATe?
Returns the
current setting for the audio/video timing measurement mode.
:OUTPut<1|2>:VIDeo:EFILte r:STATe <Boolean>
Enables or disables edge filtering for the specified generator output. If
disabled, test signals with quick, large data transitions will exhibit ringing
when viewe
d with a waveform display.
:OUTPut<1|2>:VIDeo:EFILte r:STATe?
Returns the current setting f or edge filtering for the specified generator output.
:OUTPut<1|2>:VPID:STATe <Boo lean>
Enables or disables the automatic insertion of the SMPTE 352M Video
Payload Identifier in the ancillary data for the specified generator output.
:OUTPut<1|2>:VPID:STATe?
Returns the current setting for the Video Payload Identifier insertion for the
specified generator output.
:OUTPut<1|2>:ZONE:FREQuen cy <NR2>
Sets
the control frequency parameter value for the zone plate test pattern
(when selected). See the SDI7 module section of the TG8000 User Manual
for a desc ription of the control parameter for each type of zone plate pattern.
:OUTPut<1|2>:ZONE:FREQuen cy?
Re
turns the frequency parameter for the zone plate test pattern.
:OUTPut<1|2>:ZONE:AMPLitu de <NR2>
Sets the amplitude (in millivolts) for the zone plate test pattern. The maximum
value is 700 mV.
:OUTPut<1|2>:ZONE:AMPLitu de?
Returns the value of the zone plate amplitude.
:OUTPut<1|2>:ZONE:K <NR2>
Sets the value of the K parameter (phase) for the zone plate tes t pattern.
:OUTPut<1|2>:ZONE:K?
Returns the value of the K parameter for t he zone plate test pattern.
:OUTPut<1|2>:ZONE:KX <NR2>
Draft
168 TG8000 Multiformat Test Signal Generator Programmer Manual
To Next Page
Loading...
Need help?
General
