Important safety information
To avoid fire or
personal
injury
Use proper powe
r cord. Use only the power cord specified for this product and
certified for the country of use.
Do not use the p
rovided power cord for other products.
Ground the product. This product is grounded through the grounding conductor
of the power cord. To avoid electric shock, the grounding conductor must be
connected to earth ground. Before making connections to the input or output
terminals of the product, make sure that the product is properly grounded.
Do not disable the power cord grounding connection.
Power disconnect. The power cord disconnects the product from the power
source. S
ee instructions for the location. Do not position the equipment so that it
is difficult to disconnect the power cord; it must remain accessible to the user at
all times to allow for quick disconnection if needed.
Observe all terminal ratings. To avoid fire or shock hazard, observe all ratings
and markings on the product. Consult the product manual for further ratings
infor
mation before making connections to the product.
Do not apply a potential to any terminal, including the common terminal, that
excee
ds the maximum rating of that terminal.
Do not operate without covers. Do not operate this product with covers or panels
removed, or with the case open. Hazardous voltage exposure is possible.
Avoid exposed circuitry. Do not touch exposed connections and components
whe
n power is present.
Do not operate with suspected failures. If you suspect that there is damage to this
product, have it inspected by qualified service personnel.
Disable the product if it is damaged. Do not use the product if it is damaged
or operates incorrectly. If in doubt about safety of the product, turn it off and
disconnect the power cord. Clearly mark the product to prevent its further
operation.
Before use, inspect voltage probes, test leads, and accessories for mechanical
damage and replace when damaged. Do not use probes or test leads if they are
damaged, if there is exposed metal, or if a wear indicator shows.
Examine the exterior of the product before you use it. Look for c racks or missing
pieces.
Use only specifi ed replacement parts.
Do not operate in wet/damp conditions. Be aware that condensation may occur if
a unit is m oved from a cold to a warm environment.
xiv TG8000 Multiformat Test Signal G enerator User Manual
To Next Page
Loading...
Need help?
General
