Tektronix TG8000 User Manual

ATG7 Analog Test Generator module
ATG7 module
SELECT SIGNAL submenu
Usethismenuto
select an output signal for the BLACK 1, BLACK 2, or BARS
connector. The following figure shows the SELECT SIGNAL submenu.
Figure 3-12: ATG7 module SELECT SIGNAL submenu
Use the left (◄)orright(►) a rrow button to scroll through the selections. Press
the ENTER button to enable the selected signal.
Which s
ignals are available depend on the selected output connector and the video
format. The following table lists the available signals for each output connector
and video format.
Table 3-6: Test signals in the ATG7 m odule SELECT SIGNAL submenu
Format Test signals
BLACK1 and BLACK 2 connectors
NTSC and NTSC No Setup
Black Burst, Black Burst with Field REF,
Composite Sync, Composite Blanking,
Subcarrier, H Drive, V Drive, Field Reference
PAL
Black Burst, Black Burst No Field REF, Composite
Sync, Composite Blanking, Subcarrier, H Drive,
V Drive, Field Reference, PAL Pulse
BARS connector
NTSC and NTSC No Setup Black Burst, Black Burst with Field REF, 100%
Color Bar, 75% Color Bar, SMPTE Color Bar,
40% Flat Field, O ther 1 (SNG Color Bars), Other
2 (Monitor Setup Matrix)
PAL
Black Burst, Black Burst No Field REF, 100%
Color Bar, 75% Color Bar, 100% Color Bar Over
Red, 75% Color Bar Over Red, 40% Flat Field,
Other 1 ( 4 Level Pedestal & Pluge), Other 2
(Monitor Setup Matrix)
3–24 TG8000 Multiformat Test Signal Generator User Manual

Tektronix TG8000 Specifications

General

Brand	Tektronix
Model	TG8000
Category	Portable Generator
Language	English