HD3G7 HD 3 Gb/s SDI Video Generator module
Table 3-37: HD3G7 module signal sets assigned to the test signal buttons (cont.)
Button name Signals in the signal set Description
Black to White-1, Black to White-2,
Black to White-3, Black to White-4,
Black to White-5, Black to White-6,
Black to White-7, Black to White-8,
Black to White-9, Black to White-10,
Black to Gray-1, Black to Gray-2,
Black to Gray-3, Black to Gray-4,
Black to Gray-5, Black to Gray-6,
Black to Gray-7, Black to Gray-8,
Black to Gray-9, Black to Gray-10
Full-frame monochrome flat fields representing the individual
steps in the SMPTE EG 432–1 step-scale patterns available under
the MONITOR button.
These signals are not part of the factory installed signal sets. You
must install the enhanced signal se ts to access these signals.
(See page 3-171, To install the HD3G7 module enhanced signal
sets.)
Red-1 Field, Red-2 Field,
Green-1 Field, Green-2 Field,
Blue-1 Field, Blue-2 Field,
Cyan-1 Field, Cyan-2 Field,
Magenta-1 Field, Magenta-2 Field,
Yellow-1 Field, Yellow-2 Field
Full-frame color flat fields representing the individual colors in
the SMPTE EG 432–1 color-accuracy patterns available under
the COLOR BAR button.
These signals are not part of the factory installed signal sets. You
must install the enhanced signal se ts to access these signals.
(See page 3-171, To install the HD3G7 module enhanced signal
sets.)
MULTIBURST
——
No test signals are currently available for the MULTIBURST signal
set.
SWEEP Circle, Diagonal Sine,
H Sine, H Sweep, V Sine, V Sweep,
Custom-1, Custom-2
Zone plate test signal with real-time parametric controls. (See
page 3-172, HD3G7 module zone plate signals.)
MONITOR ChromaDuMonde Color reference chart, used with permission of DSC Laboratories.
The pattern consists of a series of DSC standard color patches
representing the six primary colors, 18 evenly spaced intermediate
colors, and four skin tone reference patches. The 24 primary
and intermediate colors will show as a hexagonal shape on a
vectorscope display, providing a reference for comparison with a
camera-generated image of a physical DSC ChromaDuMonde
chart. The pattern also includes an 11-step crossed grayscale
section and a center section with 0% black and 100% white
patches.
SMPTE 303M Color Reference Color reference chart per SMPTE 303M, also known as the
GretagMacbeth ColorChecker® chart. Note that cyan patch #18
cannot be reproduced properly in the RGB and XYZ color spaces
because the red component lies at approximately −14%, which
exceeds legal limits for RGB formats. T his patch will appear as
a cyan and black c heckerboard pattern, where the cyan patches
are of a different hue than the full cyan patch as seen in YCbCr
formats because the red component is clipped at 0%. The color
values used from SMPTE 303M are those with respect to the D
65
illuminant.
3–168 TG8000 Multiformat Test Signal Generator User Manual
To Next Page
Loading...
