Tektronix TG8000 User Manual

HD3G7 HD 3 Gb/s SDI Video Generator module
TEMPERATURES.
This diagnostic displays the temperature of the HD3G7 module
board and FPGA.
FPGA VERSION. This diagnostic displays the current and expected FPGA
versions. If there is a discrepancy between the two, a warning appears, which
means that the FPGA firmware might need to b e upgraded.
VOLTAGE MON 1. This diagnostic measures internal voltage supplies. If these
supplies are outside the nominal range, a warning appears, which means that the
instrument should be serviced.
VOLTAGE MON 2. This diagnostic measures internal voltage supplies. If these
supplies
are outside the nominal range, a warning appears, which means that the
instrument should be serviced.
VOLTAGE MON 3. This diagnostic measures internal voltage supplies. If these
supplies are outside the nominal range, a warning appears, which means that the
instrument should be serviced.
VOLTAGE MON 4. This diagnostic measures internal voltage supplies. If these
supplies are outside the nominal range, a warning appears, which means that the
instrument should be serviced.
HD3G7 module
CALIBRATION submenu
This menu is accessible only when the instrument is in factory mode. From
this menu, you can access se veral special output signals and adjust the serial
output levels. The special signals are unscrambled and are synchronous with
the clock out of the trigger BNC. T hey are used to check performance or used
when adjusting serial levels. See the TG8000 Service Manual for information on
ad
justments and using factory mode.
TG8000 Multiformat Test Signal Generator User Manual 3–211

Tektronix TG8000 Specifications

General

Brand	Tektronix
Model	TG8000
Category	Portable Generator
Language	English