Tektronix TG8000 User Manual

SDI7 Dual Channel SD/HD/3G SDI Video Generator module
Status. Use thi
s menu to set the status of the individual channel. Use the left (◄)
or right (►) arrow button to select between Active, Inactive,andMute. Press the
ENTER button to confirm the selection.
Frequency. Use this m enu to set the frequency of the Embedded Audio signal
from 10.0 Hz to 20 kHz, in steps of 0.5 Hz. Press the ENTER button to enter the
adjustment
mode, then use the left (◄) and right (►) arrow buttons to position
thecursor,andthenusetheup(▲) and down (▼) arrow buttons to set the number
for that position. Press the ENTER button again to confirm the new frequency.
Amplitude. Use this menu to set the audio amplitude from –60 dBFS to 0 dBFS,
in steps of 1 dBFS. Use the left (◄) and right (►) arrow buttons to set the
amplitud
e, and then press the ENTER buttontoconfirm it.
Audio Click. Use this menu to set the audio click rate to one click every one,
two, three, or four seconds, o r turn the click off. Use the left (◄)orright(►)
arrow button to select the click rate, and then press the ENTER buttontoconfirm
the selection.
Channel Origin. Use this menu to set a channel origin ID of up to four ASCII
characters. Use the left (◄) and right (►) arrow buttons to position the cursor,
andthenusetheup(▲) and down (▼) arrow buttons to set the ID. Press the
ENTER buttontoconfirm the Channel Origin ID.
TG8000 Multiformat Test Signal Generator User Manual 3–305

Tektronix TG8000 Specifications

General

Brand	Tektronix
Model	TG8000
Category	Portable Generator
Language	English