Tektronix TG8000 User Manual

SDI7 Dual Channel SD/HD/3G SDI Video Generator module
DOLBY-E METADA
TA Downmix Preferred. Use this menu item to set the preferred
downmix of the Dolby E signal. This parameter is used in consumer decoders that
have stereo outputs. This parameter is part of the extended BSI.
Use the left (◄)andright(►) arrow buttons to select LoRo, Not Indicated,or
LtRt.PressENTER to confirm the selection.
DOLBY-E METADATA LtRt Center Mix Level. Use this menu item to set the LtRt
center mix level of the Dolby E signal. This parameter indicates what level
shift shou
ld be applied to the center channel before adding it to the left and
right channels when downmixing to an LtRt output. This parameter is part of
the extended BSI.
Use the left (◄)andright(►) arrow buttons to select –3.0 dB, –4.5 dB, –6.0 dB,
Infinite, +3.0 dB, +1.5 dB, 0.0 dB,or–1.5 dB.PressENTER to confirm the
selection.
DOLBY-E METADATA LtRt Surround Mix Level. Use this menu item to set the LtRt
surrou
nd mix level of the Dolby E signal. This parameter indicates what level
shift should be applied to the surround channels before adding them to the left
and right channels when downmixing to an LtRt output. This parameter is part of
the extended BSI.
Use the left (◄)andright(►) arrow buttons to select –3.0 dB, –4.5 dB, –6.0 dB,
Infinite, +3.0 dB, +1.5 dB, 0.0 dB,or–1.5 dB.PressENTER to confirm the
selection.
DOL
BY-E METADATA LoRo Center Mix Level. UsethismenuitemtosettheLoRo
center mix level of the Dolby E signal. This parameter indicates what level
shift should be applied to the center channel before adding it to the left and
right channels when downmixing to an LoRo o utput. This parameter is part of
the extended BSI.
Use the left (◄)andright(►) arrow buttons to select –3.0 dB, –4.5 dB, –6.0 dB
,
Infinite, +3.0 dB, +1.5 dB, 0.0 dB,or–1.5 dB.PressENTER to confirm the
selection.
DOLBY-E METADATA LoRo Surround Mix Level. Use this menu item to set the
LoRo surround mix level of the Dolby E signal. This parameter indicates what
level shift should be applied to the surround c hannels before adding them to the
left and right channels when downmixing to an LoRo output. This parameter is
part of the extended BSI.
Use the left (◄)andright(►) arrow buttons to select –3.0 dB, –4.5 dB, –6.0 dB,
Infinite, +3.0 dB, +1.5 dB, 0.0 dB,or–1.5 dB.PressENTER to confirm the
selection.
3–310 TG8000 Multiformat Test Signal Generator User Manual

Tektronix TG8000 Specifications

General

Brand	Tektronix
Model	TG8000
Category	Portable Generator
Language	English