Televes 769501 - 7.2.6 “voice” node

176
GPON ONT
7.2.6 “voice” node
This node can be used to congure the voice-related parameters. Only SIP is supported and there are two SIP accounts available.
This command also allows the start/stop of the voice application, as well as restoring the settings to their default values.
NOTE: At this point, only the conguration of basic voice parameters is supported. Full support must be available in the next versions.
+ voice[@restore-default, @show, @start, @stop]
+ sip[@cong, @show]
+ account0[@cong, @show]
+ account1[@cong, @show]
Figure 7-6: voice node tree
7.2.6.1 Permissions
Command Admin Support User
/voice/restore-default Yes Yes No
/voice/show Yes Yes Yes
/voice/start Yes Yes No
/voice/stop Yes Yes No
/voice/sip/show Yes Yes No
/voice/sip/cong Yes Yes No
/voice/sip /account0/show Yes Yes No
/voice/sip /account0/cong Yes Yes No
/voice/sip /account1/show Yes Yes No
/voice/sip /account1/cong Yes Yes No
Table 7-36: voice node and sub-node tree command permissions