Televes 769501 - 7.2.8 “routing” node

180
GPON ONT
7.2.7.2.3 “outgoing” sub-node
By default, all outgoing IP trac from LAN is allowed, but some IP trac can be BLOCKED by setting up lters. The aim of this sub-node is to allow
the conguration of those lters.
7.2.7.2.3.1 “create” command
Name create
Description Creates a lter
Full path /security/ip-ltering/outgoing/create
Arguments
<MANDATORY>
--dest-ip Destination IP address
--dest-port Destination port
--ip-version IP version <IPv4|IPv6>
--name Filter name
--protocol Protocol <TCP/UDP|TCP|UDP|ICMP>
--src-ip Source IP address
--src-port Source port
Table 7-42: “create” command information
7.2.7.2.4 “remove” command
Name remove
Description Removes an existing lter
Full path /security/ip-ltering/ougoing/remove
Arguments
<MANDATORY> --name-to-rmv Filter name to remove
Table 7-43: “remove” command information
7.2.8 “routing” node
This node allows the conguration of some routing settings.
+ routing[]
+ defaultgw[@cong, @show]
+ static-route[@cong, @remove, @show]
Figure 7-8: routing node tree