Temptronic ThermoStream TP04100A - 3-12.4 Program Test Setup Screen; Figure 3-12 Program Test Setup Screen; Ramp Upidown; Setpoints Per Test Setup

Rev A: 0611 5/98
3-12.4 Program Test Setup Screen
System Operation
TP04100A Interface
& Applications
Figure 3-12 Program Test Setup Screen
To access the Program Test Setup Screen (see Figure 3-12, above): from either the Top Menu Screen or Setup
Options Screen,
select the Program Button under "Program," then from the Program Operation Screen, select
the "Setup" Program Button.
Note, that if the
Manual Test Setup Screen is seIected, then only three setpoints will be displayed: Hot,
Ambient, and Cold (see the
TP04100A Operator's Manual). To change from Manual mode to Program mode,
press ESC twice to access the
Top Menu Screen, then follow the instructions in the first paragraph of this
section to access the
Program Test Setup Screen.
The Program Test Setup Screen consists of five program button functions and five windows:
Functions: ESC, SELECT, DEFINE, ADD, DONE (press button below function to execute)
Ramp "UPIDOWN Fields
Temperature Band: "WINDOW
Number of "CYCLES"
Test Setups: "0
- 9''
Setpoints (per Test Setup): "Add," ""C," "Secs (Soak Time, Seconds)"
Use the Rotary Encoder (see Table 3-1) to navigate the five windows (except "Test Setups 0-9," which uses
the "Select" program button) as follows: rotate Encoder knob to highlight the desired field, then, to change
setpoints, press Encoder knob inward to enter Change Mode (highlighted field blinks); rotate Encoder knob; at
desired value, press Encoder knob inward to accept new value and exit Change Mode.
The function selections at the bottom of the display screen in Figure
3-12 are summarized as follows.
Page 3-33
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com