System Operation
Rev A: 0611
5/98
TP04100A Interface
&
Applications
3-14
DUT
Mode
Test Setup
3-14.1
Overview
DUT mode requires the user to install an external thermocouple sensor directly to the DUT to control
temperature. See Section
2
for guidelines on attaching thermocouples to DUTs. See Section
5,
"Thermocouple
Input Access" for locations of thermocouple receptacles.
To optimize testing in DUT mode, and to set up the fastest possible temperature transition times while
minimizing the amount of undershoot and overshoot, see "DUT self Tuning control," Section 3-12.3.4, on
page 3-30.
Following is a setup for DUT mode. See the
Define Parameters Screen
for detailed explanations of each
parameter.
Once parameters are defined, then use the
Program Operation Screen
to conduct the tests first setup on the
Program Test Setups Screen.
For a flow diagram of the thirteen TP04100A screens, see the Screen Tree in Section 3-17 on page3-48.
Page
3-42
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
